A new series of Sm3+ ions doped sodium fluoroborate glasses have been synthesized following the melt quenching technique. The structural analyses… Continue reading Concentration effect on the structural and spectroscopic investigations of Sm3+ ions doped B2O3–Bi2O3–CaF2–Na2O glasses
Leah Pandiscia, PhD
October 11, 2018
Bismuth ferrite (BFO) nanoparticles prepared by solid state reaction route were characterized by various characterization techniques such as XRD, FESEM,… Continue reading Synthesis, photoelectrochemical properties and solar light-induced photocatalytic activity of bismuth ferrite nanoparticles
Leah Pandiscia, PhD
October 11, 2018
Dy3+-doped yttrium orthosilicate (Y2SiO5, abbreviated YSO) phosphors were synthesized: (1) by conventional high temperature solid-state method using two types of fluxes:… Continue reading Synthesis and photoluminescent properties of the Dy3+doped YSO as a high-temperature thermographic phosphor
Leah Pandiscia, PhD
October 11, 2018
Leah Pandiscia, PhD
October 11, 2018
Leah Pandiscia, PhD
October 11, 2018
The ternary composites consisted of nitrogen-doped titanium dioxide, carbon nitride and up-conversion phosphors (UP) were successfully prepared by a solvothermal… Continue reading N-TiO2/g-C3N4/Up-conversion phosphor composites for the full-spectrum light-responsive deNO x photocatalysis
Leah Pandiscia, PhD
October 11, 2018
Ex situ Raman spectroscopy and Raman mapping showed that at temperatures below 1300 °C, magnesia reacted with either alumina or… Continue reading Ex situ Raman mapping study of mechanism of cordierite formation from stoichiometric oxide precursors
Carlos Morillo
October 5, 2018
Vertically aligned carbon nanotubes have been synthesized from botanical hydrocarbons: Turpentine oil and Eucalyptus oil on Si(100) substrate using Fe… Continue reading Vertically aligned carbon nanotubes from natural precursors by spray pyrolysis method and their field electron emission properties
Carlos Morillo
October 5, 2018
The dissolution of most common multicomponent silicate minerals and glasses is typically incongruent, as shown by the nonstoichiometric release of… Continue reading Mechanism of leached layer formation during chemical weathering of silicate minerals
Carlos Morillo
October 5, 2018
The thermal conductivities of ultrahigh tensile strength polyacrylonitrile (PAN)-based (T1000GB) and ultrahigh modulus pitch-based (K13D) carbon fibers with carbon nanotubes… Continue reading Enhancing the thermal conductivity of polyacrylonitrile- and pitch-based carbon fibers by grafting carbon nanotubes on them
Carlos Morillo
October 5, 2018
Carlos Morillo
October 5, 2018
The aim of this study was to ascertain whether zinc may improve the repair ability of demineralized dentin. Dentin disks… Continue reading Zinc Induces Apatite and Scholzite Formation during Dentin Remineralization
Carlos Morillo
October 5, 2018
Carlos Morillo
October 5, 2018
Design of restorative materials should be focused on promoting not only adhesion but also dentine self-repair processes. Objective To ascertain… Continue reading Design of restorative materials should be focused on promoting not only adhesion but also dentine self-repair processes
Carlos Morillo
October 5, 2018
Graphene quantum dots (GQDs) were prepared using a top-down approach with a green microwave-assisted hydrothermal synthesis from ultrathin graphite, previously… Continue reading Green and fast synthesis of amino-functionalized graphene quantum dots with deep blue photoluminescence
Carlos Morillo
October 5, 2018
Mechanochemically activated graphite (Gp) and iron particle surfaces were prepared, and the Gp/iron composite interfaces were elucidated to utilize new… Continue reading Effective Composite Preparation between Graphite and Iron Particles by the Interfacial Mediation of Force-Activated Oxygen Atoms
Carlos Morillo
October 5, 2018
This study reports physical and chemical changes that occur at early dentin remineralization stages. Extracted human third molars were sectioned… Continue reading Surface Microanalysis and Chemical Imaging of Early Dentin Remineralization
Carlos Morillo
October 5, 2018
Certain molten complexes of Li salts and solvents can be regarded as ionic liquids. In this study, the local structure… Continue reading Li+ solvation in glyme–Li salt solvate ionic liquids
Heather Haffner
October 5, 2018
A novel proton-conducting material, BaScO2(OH) has been successfully fabricated. The known high-temperature proton conductors are typically perovskite-type oxides, in which… Continue reading Perovskite-Structured BaScO2(OH) as a Novel Proton Conductor: Heavily Hydrated Phase Obtained via Low-Temperature Synthesis
Carlos Morillo
October 5, 2018
Carlos Morillo
October 5, 2018