Detection of Phosphorescence from Singlet Oxygen using NIR Spectrofluorometer

January 5, 2024

Introduction

FP-8700 Spectrofluorometer
FP-8700 Spectrofluorometer

While oxygen molecules are typically in a triplet ground state, if enough energy is delivered to the molecule they can be excited to produce singlet oxygen. However, this transition is forbidden and does not proceed directly, in which case a photosensitizer is used to induce a molecular reaction. Optical irradiation excites the photosensitizer from its singlet ground state to a singlet excited state. It then changes to a triplet excited state by intersystem crossing. If the energy difference between this triplet state and the singlet ground state for the photosensitizer is almost the same as that between the singlet excited state and the triplet ground state for oxygen, energy transfer occurs. As the triplet excited photosensitizer loses its energy, singlet oxygen is produced.

 

Mechanism for the generation of singlet oxygen.
Figure 1. Mechanism for the generation of singlet oxygen.

Singlet oxygen is highly active and destroys biological molecules. Recently, its use for destroying cancer cells or bacteria has been researched. Herein, we describe measurements of phosphorescence at 1270 nm emitted by singlet oxygen using a JASCO near-infrared (NIR) FP-8700 spectrofluorometer with Eosin Y as a photosensitizer.

Experimental

Measurement Conditions
Emission Wavelength1200 - 1350 nmExcitation Wavelength300 - 700 nm
Excitation Step5 nmData Interval2 nm

Keywords

250-FP-0023, FP-8700, Singlet oxygen, Phosphorescence, Photosensitizer

Results

EEM and emission spectra (λEx: 525 nm) of singlet oxygen.
Figure 2. EEM and emission spectra (λEx: 525 nm) of singlet oxygen.

The excitation emission matrix (EEM) of EosinY ethanol solution is shown in Figure 2. The phosphorescence of singlet oxygen around 1270 nm was detected when the excitation wavelength range is 470-560 nm. The EEM measurement of singlet oxygen reveals a suitable excitation wavelength as well as whether the singlet oxygen has been generated.

This document has been prepared based on information available at the time of publication and is subject to revision without notice. Although the contents are checked with the utmost care, we do not guarantee their accuracy or completeness. JASCO Corporation assumes no responsibility or liability for any loss or damage incurred as a result of the use of any information contained in this document. Copyright and other intellectual property rights in this document remain the property of JASCO Corporation. Please do not attempt to copy, modify, redistribute, or sell etc. in whole or in part without prior written permission.

Featured Products:

  • Simple and sensitive system which readily accommodates routine measurements and accessories, such as spectral scanning, quantitation, and temperature control.

    FP-8250 Spectrofluorometer

  • Sophisticated optical system offering the ultimate in sensitivity, spectral accuracy, and flexibility for the most challenging materials and biological samples.

    FP-8550 Spectrofluorometer

  • Uniquely optimized for NIR applications with extended wavelength measurement to 1010 nm.

    FP-8650 NIR Spectrofluorometer

About the Author